TM 5-3895-373-34
2.69
REPLACE/REPAIR AUGER/CONVEYOR MOTOR AND DRIVE SPROCKET WHEEL - Continued
B.
DISASSEMBLE - Continued.
Remove valve housing carefully from
auger/conveyor
motor
to
prevent
compression
springs
and
counterbalance
weight
assembly
from falling out of valve housing.
Failure to do so may result in damage
to parts.
c.
Lift
valve
housing
(64)
straight
up
off
auger/conveyor motor. Do not allow parts to fall
from valve housing.
d.
Use an o-ring tool and remove preformed
packings
(65)
and
gasket
(66).
Discard
preformed packings and gasket.
e.
Remove counterbalance weight assembly (67)
and compression springs (68).
f.
Use an o-ring tool and remove inner face seal
ring (69) and outer face seal ring (70). Discard
seal rings.
g.
Remove plugs (71), preformed packings (72),
compression springs (73) and check balls (74).
Discard preformed packings.
h.
Lift valve (75) off valve plate and valve drive
shaft.
GO TO NEXT PAGE
2-980
