TM 5-3895-373-34
2.69
REPLACE/REPAIR AUGER/CONVEYOR MOTOR AND DRIVE SPROCKET WHEEL - Continued
A.
REMOVE Continued.
Hydraulic
oil
can
be
moderately
flammable and can be an irritant to
the
skin,
eyes,
and
respiratory
system. Avoid prolonged exposure.
Eye protection and rubber gloves
must be worn when working with
hydraulic oil.
8.
DISCONNECT
HYDRAULIC
HOSES
FROM
AUGER/CONVEYOR
MOTOR
IN
AND
OUT
PORTS.
NOTE
The right auger/conveyor motor turns
counterclockwise
and
the
left
auger/conveyor motor turns clockwise.
Porting on the motors are reversed
when going from the right motor to the
left motor.
a.
Tag and disconnect hydraulic hose (38) from
auger/conveyor motor in port B elbow. Plug
hose and cap elbow.
b.
Tag and disconnect hydraulic hose (39) from
auger/ conveyor motor out port A elbow. Plug
hose and cap elbow.
9.
LOOSEN TENSION BOLTS AND REMOVE HEX
HEAD CAP SCREWS.
a.
Loosen, but do not remove, hex head cap
screws (40).
b.
Loosen hex nut (41).
c.
Back tension bolt (42) all the way down, but do
not remove hex nut and tension bolt.
d.
Remove hex head cap screws (40), washers
(43), and flat washers (44).
GO TO NEXT PAGE
2-976
