3. REMOVE CHECK VALVE, SEPARATE VALVE HOUSING FROM AUGER/CONVEYOR MOTOR, COUNTERBALANCE WEIGHT ASSEMBLY, COMPRESSION SPRINGS, AND VALVE

1. REMOVE DRIVE SPROCKET WHEEL AND MOTOR MOUNT FROM AUGER/CONVEYOR MOTOR

B. DISASSEMBLE - Continued - TM-5-3895-373-34_1009

TM-5-3895-373-34 Paving Machine Bituminous Material Crawler Mounted Diesel Engine Driven Manual
Page Navigation
1001

TM 5-3895-373-34 B. DISASSEMBLE - Continued. NOTE There are two seal kits used in repair of the auger/conveyor motor. If using a seal kit, disassemble the motor only as far as needed to replace the items contained in the seal kit being used. 3. REMOVE CHECK VALVE, SEPARATE VALVE HOUSING FROM AUGER/CONVEYOR MOTOR, COUNTERBALANCE WEIGHT ASSEMBLY, COMPRESSION SPRINGS, AND VALVE. Use caution when clamping the auger/conveyor motor in a vise. Excessive clamp pressure on housing in a vise will cause distortion and leakage. Use vise jaw caps to prevent damage to housing. a. Place auger/conveyor motor in a bench vise with output shaft down. Do not overtighten vise jaw caps. b. Remove hex head cap screws (62 and 63). GO TO NEXT PAGE 2-979

Privacy Statement
Press Release
Contact