TM 5-3895-373-34
A.
REMOVE - Continued.
10.
REMOVE TOP CHAIN COVER PLATE, LIFT
AUGER/CONVEYOR DRIVE CHAIN OFF
SPROCKET WHEEL, AND REMOVE ELBOWS.
NOTE
Hydraulic hoses routed over the top
of top chain cover plate may need to
be repositioned temporarily to gain
access to hex head cap screws and
to allow the removal of the top chain
cover plate.
a.
Remove hex head cap screws (45) and flat
washers (46).
b.
Remove top chain cover plate (47).
c.
Lift auger/conveyor drive chain (48) off of drive
sprocket wheel and secure with a string tied
where hex head cap screw (1, step A.1.a) was
secured.
d.
Remove elbows (49) from straight adapters (50).
Cap straight adapters.
11.
REMOVE STRAIGHT ADAPTERS AND AUGER/
CONVEYOR MOTOR FROM PAVING MACHINE
AND DISCONNECT AUGER/CONVEYOR DRIVE
CHAIN.
a.
For the RH auger/conveyor motor, turn the motor
and motor mount 90° clockwise as seen from
the drive sprocket wheel.
b. For the LH auger/conveyor motor, turn the motor
and motor mount 90° counterclockwise as seen
from the drive sprocket wheel.
c. Place a machinery wiping towel beneath elbow
and
straight
adapters
installed
on
the
auger/conveyor motor to be removed.
d. Using a 1-1/2 in. combination wrench, remove
straight adapters (50) and preformed packings
(51). Discard preformed packings.
e. Using an overhead hoist and sling strap, lift
auger/conveyor motor out of the paving machine
and move to a clean work area.
f. Manually reposition auger/conveyor drive chain
(48) over auger sprocket wheel and conveyor
sprocket gear to allow access to the master link.
g. Disconnect auger/conveyor drive chain (48)
paragraph 2.63, step A.7.
GO TO NEXT PAGE
2-977
