TM 5-3895-373-20
8.3.
REPLACE HYDRAULIC CHARGE FILTER ASSEMBLY - Continued.
NOTE
This procedure refers to replacing
one hydraulic charge filter assembly.
The paving machine has two charge
filter assemblies. This procedure
should be used, as needed, to replace
either or both hydraulic charge filter
assemblies.
A. REMOVE.
WARNING
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
lll cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
1.
CLEAN OUTSIDE SURFACE OF HYDRAULIC
CHARGE
FILTER
ASSEMBLY
(1)
WITH
CLEANING
SOLVENT
AND
CLEANING
CLOTH. PAY PARTICULAR ATTENTION TO
HOSE ENDS AND HYDRAULIC FITTINGS.
GO TO NEXT PAGE
8-10
