2. REPAIR ELECTRICAL CONNECTORS.

B. REPAIR - Continued - TM-5-3895-373-20_810

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
801

TM 5-3895-373-20 B. REPAIR - Continued. 2. REPAIR ELECTRICAL CONNECTORS. a. Tag and disconnect electrical connector halves and remove secondary locks. (1) Determine what type of electrical connector will be serviced. Refer to chart in paragraph B.1. (2) Tag each wire (18) to be removed from electrical connector by marking on a piece of tape, in pen, which terminal wire came from. (3) Place tape (19) onto wire (18) to be removed. (4) Pull electrical connector (20) halves apart. NOTE When removed, some secondary locks will not remain attached to electrical connectors. If secondary locks are not attached to connectors, remove them entirely from the connectors. (5) Use a flat-blade screwdriver to remove secondary lock (21) on electrical connector (20), where applicable. b. Remove pin terminals from electrical connectors and wiring harness. (1) Determine which pin terminal removal tool to use. Refer to chart in paragraph B.1. (2) Insert appropriate tool into open end of electrical connector (I through 6) to release pin terminals. GO TO NEXT PAGE 7-159

Privacy Statement
Press Release
Contact