TM 5-3895-373-20 7.21. REPAIR ELECTRICAL HARNESSES - Continued. B. REPAIR. NOTE This   procedure   covers   the   removal and installation of electrical connectors and electrical coil connectors;    ring    terminals,    tongue terminals,  and  spade  terminals;  and the  repair  of  electrical  harnesses    by installation of a wire by "piggyback"  method  on  the  harness itself.        This    paragraph    provides    a listing of types of electrical connectors and terminals and methods   of   repair   and   replacement. Perform only those procedures listed to    repair    or    replace    the    defective electrical connector or terminal. 1. GENERAL REPAIR INSTRUCTIONS. a. Refer  to  illustration  and  chart  below  for  a listing  of  the  types  of  electrical  connectors and wire terminals in the first column.  The second  column  lists  specific  tools  required for repair of the item listed.  If a specific tool is not listed, then the use of common tools in  the  electrical  connector  repair  kit  is  all that  is  required.  The  third  column  lists  the paragraph  where  the  instructions  to  repair the item occurs. ITEM TO BE REPAIRED TOOL REQUIRED PARAGRAPH Electrical connector (7) Narrow, flat-blade tool B.2 Electrical connector (8) Round, hollow tool B.2 Electrical connector (9) Wide, flat-blade tool B.2 Electrical connector (10) Wide, flat-blade tool B.2 Electrical connector (11) Round, hollow tool B.2 Electrical connector (12) Round, hollow tool B.2 Electrical coil connector (13) B.3 Ring terminal (14) B.4 Tongue terminal (15) B.4 Spade terminal (16) B.4 Wiring harness (17) B.5 b. Cut tie wraps that are in the way of accessing electrical connectors, terminals, and wiring harnesses.  Discard tie wraps. GO TO NEXT PAGE 7-158