B. REPAIR - Continued - TM-5-3895-373-20

B. REPAIR - Continued - TM-5-3895-373-20_811

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
802

TM 5-3895-373-20 7.21. REPAIR ELECTRICAL HARNESSES - Continued. B. REPAIR - Continued. (3) Grasp electrical connector and gently pull on wire (18) from behind electrical connector (20). (4) Pull pin terminals (22) determined faulty from each electrical connector. NOTE Terminals must be cut from wiring harness directly behind dust and moisture boot to conserve wire length in electrical harness. (5) Use wire cutters to cut, one wire at a time, pin terminals (22) from wires (18). Cut directly behind dust and moisture boot (23) to conserve wire length. Discard pin terminal and dust and moisture boot. (6) Do not allow wire harness identification tags (24) to fall from wire (18). c. Install new pin terminals onto wiring harness and into electrical connectors. NOTE Ensure dust and moisture boot is installed with ribbed end of boot away from cut end of wire. (1) Slip dust and moisture boot (23) over cut end of wire (18), away from end of wire to allow room for wire strippers. GO TO NEXT PAGE 7-160

Privacy Statement
Press Release
Contact