7.21. REPAIR ELECTRICAL HARNESSES - Cont

B. REPAIR - Continued - TM-5-3895-373-20_811

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
804

TM 5-3895-373-20 7.21. REPAIR ELECTRICAL HARNESSES - Continued. B. REPAIR - Continued. (5) Slide dust and moisture boot (23) into pin terminal (22), allowing approximately 0.76 in. (19,5 mm) from edge of pin terminal locking tangs to back of boot. (6) Use needle nose pliers to bend pin terminal (22) insulation wings over dust and moisture boot (23). (7) Install pin terminals (22) into electrical connector (20) until an audible "click" is heard. (8) Pull gently backward on wire (18) to seat pin terminal (22) inside electrical connector (20). GO TO NEXT PAGE 7-162

Privacy Statement
Press Release
Contact