TM 5-3895-373-20
7.21.
REPAIR ELECTRICAL HARNESSES.
This task covers:
a. Remove
b. Repair c. Install
INITIAL SETUP
Tools:
References:
General mechanics automotive tool kit
TM 5-3895-373-10
(Item 54, Appendix E)
TM 5-3895-373-24P
Electrical connector repair kit (Item 53, Appendix E)
MIL-STD-2000A
Heater gun (Item 21, Appendix E)
Solder (Item 47, Appendix E)
Equipment Condition:
Soldering iron (Item 23, Appendix E)
Rear top left access door opened per TM 5-3895-373-10.
Left access cover removed per TM 5-3895-373-10.
Materials/Parts:
Adhesive (Item 1, Appendix C)
NOTE
Electrical insulating compound (Item 11, Appendix C)
Electrical insulating varnish (Item 32, Appendix C)
Open other access door(s) and remove
Electrical tape (Item 17, Appendix C)
access
Tape (Item 28, Appendix C)
cover(s) as necessary to repair
electrical
Tie wraps (Item 29, Appendix C)
harnesses. Refer to paragraph 2.22
and to Dust and moisture boots
TM 5-3895-373-10.
Electrical coil connectors
Electrical connectors
Pin terminals
Ring terminals
Shrink tubing
Spade terminals
Splice clips
Tongue terminals
GO TO NEXT PAGE
7-156
