TM 5-3895-373-20
7.21.
REPAIR ELECTRICAL HARNESSES - Continued.
B.
REPAIR Continued.
(3)
Loosen and remove nut (30) and
washer (31).
NOTE
Use care not to cut wire insulation.
(4)
Use a small, flat blade screwdriver to
pry out seal (32).
(5)
Use a knife to cut and remove shrink
tubing (33). Discard shrink tubing.
(6)
Note position of base (34) as installed
in cover (35) using straight cavity as a
reference.
(7)
Use a small, flat blade screwdriver to
pry cover (35) from base (34).
(8)
Note, on paper, the positions of wires
(36) on base (34) terminals, using
numbers printed on terminals for
reference.
(9)
Loosen screws (37) and pull wires
(36) from terminals in base (34).
Discard base.
(10) Pull cover (35), seal (32), washer (31),
and nut (30) from wires (36). Discard
cover, seal, washer, and nut.
b.
Install electrical coil connector on wiring
harness.
(1)
Install nut (30), washer (31), seal (32),
shrink tubing (33), and cover (35) onto
wires (36).
(2)
Install wires (36) into base (34)
terminals, referring to note made
during disassembly.
(3)
Tighten screws (37) to secure wires
(36).
(4)
Snap cover (35) over base (34).
Position base into cover as noted
during disassembly.
(5)
Install shrink tubing (33) into opening
on cover (35), as far as it can go.
(6)
Secure shrink tubing (33) to wires with
a heat gun.
(7)
Install seal (32) over shrink tubing
(33).
(8)
Install washer (31) and secure with nut
(30).
GO TO NEXT PAGE
7-164
