TM 5-3895-373-20
B.
REPAIR - Continued.
NOTE
Some electrical connectors do not
use all cavities. A seal plug is
required when one-or more cavities
are not in use. If seal plugs or dust
and moisture boots are not available
at the time of repair, it is permissible
to fill the unused terminal with
adhesive.
d.
Install seal plugs, dust and moisture boots,
and
secondary
locks
onto
electrical
connectors
and
connect
electrical
connector halves.
(1)
Install seal plugs (25) into unused
terminals on electrical connectors
(20).
(2)
Install secondary locks (21) where
applicable.
(3)
Apply electrical insulating compound
to male half of electrical connectors
(20).
(4)
Connect
electrical
connector
(20)
halves.
3.
REPAIR ELECTRICAL COIL CONNECTORS.
NOTE
Electrical coil connectors are found
on the stack valve.
a.
Remove electrical coil connector
from
wiring harness.
(1)
Remove screw (26) and pull electrical
coil connector (27) from stack valve
(28).
(2)
Remove and discard moisture seal
(29).
GO TO NEXT PAGE
7-163
