TM 5-3895-373-20 7.20. REPLACE BATTERY CABLES - Continued. B. INSTALL - Continued. 5. INSTALL  NEGATIVE  BATTERY  CABLE  AND SHUNT GROUND CABLE. WARNING Thread    locking    compound    solvent can  cause  eye  damage.    Wear  safety goggles/glasses  when  using.    Avoid contact with eyes.  If solvent contacts eyes, flush with water and get immediate medical attention. a. Clean  threads  of  hex  head  cap  screws  (8 and    11)    with    thread    locking    compound solvent. b. Install flat washer (13) and lockwasher (12) onto hex head cap screw (11). WARNING Thread locking  compound  can  cause eye damage. Wear safety goggles/glasses  when  using.    Avoid contact    with    eyes.        If    compound contacts  eyes,  flush  eyes  with  water and get immediate medical attention. c. Apply  thread  locking  compound  to  threads of hex head cap screw (11). d. Install  shunt  ground  cable  (10)   and   DCA ground   wire   (14)   to   fuel   tank   mounting bracket   and   secure   with   hex   head   cap screw (11). WARNING Electrical    insulating    varnish    fumes can be harmful if inhaled.  Use only in a well ventilated area. Avoid prolonged    exposure    to    fumes.        If personnel   become   dizzy   or   drowsy during   use,   get   immediate   medical attention. e. Tighten hex head cap screw (11) to 30 lb-ft (40    N•m).        Apply    electrical    insulating varnish    to    cap    screw    and    fuel    tank mounting bracket. f. Install  lockwashers  (9)  onto  hex  head  cap screws (8). g. Apply  thread  locking  compound  to  threads of hex head cap screws (8). h. Install negative battery cable (5)  and  shunt ground cable (10) to shunt and secure with hex head cap screws (8). i. Tighten hex head cap screws (8) to 15 lb-ft (20    N•m).        Apply    electrical    insulating varnish to cap screws and shunt. j. Apply   electrical   insulating   compound   to DCA harness connector (7).  Connect DCA harness connector to negative battery cable harness. GO TO NEXT PAGE 7-154