2. INSTALL STARTER CABLES AND ENGINE HARNESS WIRES

3. INSTALL BATTERY CABLES - TM-5-3895-373-20_668

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
659

TM 5-3895-373-20 B. INSTALL - Continued. 2. INSTALL STARTER CABLES AND ENGINE HARNESS WIRES. a. Install wire 333 (16) onto starter ground mounting stud. Install lockwasher (18) and hex nut (17). Tighten hex nut to 42 lb-ft (57 N•m). b. Install wire 166 (15) and wire 332 (14) onto starter S terminal. Install flat washer (13), lockwasher (12), and hex nut (11) and tighten hex nut. NOTE Do not use lockwasher that comes with starter and is installed on starter B terminal. Discard lockwasher. c. Install wire 331 (10) onto starter B terminal. Install positive battery cable (9) and slave cable (8). Install and tighten hex nut (7). Electrical insulating varnish fumes can be harmful if inhaled. Use only in a well ventilated area. Avoid prolonged exposure to fumes. If personnel become dizzy or drowsy during use, get immediate medical attention. d. Coat starter B and S terminals with electrical insulating varnish. Place rubber boot from slave cable over starter B terminal. GO TO NEXT PAGE 7-17

Privacy Statement
Press Release
Contact