TM 5-3895-373-207.4.REPLACE STARTER - Continued.A.REMOVE - Continued.3.REMOVE STARTER.a.Remove remaining hex nuts (19) andlockwashers (20) from starter mounting studs.Remove starter (21) from engine. Discardlockwashers.b.Remove spacer (22) from starter mountingstuds.c.Wipe down starter mounting surface (23) andspacer (22) with cleaning cloth.B.INSTALL.1.INSTALL STARTER.Thread locking compound solventcan cause eye damage. Wear safetygoggles/glasses when using. Avoidcontact with eyes. If solvent contactseyes, flush eyes with water and getimmediate medical attention.a.Clean starter mounting studs with thread lockingcompound solvent.b.Install spacer (22) and starter (21) on startermounting studs.c.Install lockwashers (20) on the two startermounting studs not used to secure wire 333.Thread locking compound can causeeye damage. Wear safetygoggles/glasses when using. Avoidcontact with eyes. If compoundcontacts eyes, flush eyes with waterand get immediate medical attention.d.Apply thread locking compound to threads ofstarter mounting studs.e.Install hex nuts (19) onto the two startermounting studs not used to secure wire 333.Tighten hex nuts to 42 lb-ft (57 N•m).GO TO NEXT PAGE7-16
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business