TM 5-3895-373-20
A.
REMOVE - Continued.
2.
REMOVE STARTER CABLES AND ENGINE
HARNESS WIRES.
a Pull off rubber boot covering starter B terminal.
b.
Remove hex nut (7) from starter B terminal.
Remove slave cable (8), positive battery cable
(9), and wire 331 (10) from starter B terminal.
c.
Remove hex nut (11), lockwasher (12), and flat
washer (13) from starter S terminal. Remove
wire 332 (14) and wire 166 (15) from starter S
terminal. Discard lockwasher.
d.
Locate wire 333 (16) on one of the starter
mounting studs. Remove hex nut (17) and
lockwasher (18). Remove wire 333 from starter
ground mounting stud. Discard lockwasher.
GO TO NEXT PAGE
7-15
