2. REMOVE RELAY WIRES - TM-5-3895-373-20

2. CONNECT RELAY WIRES TO RELAY - TM-5-3895-373-20_671

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
662

TM 5-3895-373-20 7.5. REPLACE START RELAY - Continued. A. REMOVE - Continued. 2. REMOVE RELAY WIRES. a. Remove hex nuts (7) and flat washers (8) from both relay switch terminals. b. Tag and remove wires 167 (9 and 10) from relay switch terminal. Tag and remove wire 166 (11) from opposite relay switch terminal. c. Remove hex nuts (12) and flat washers (13) from both relay coil terminals. d. Tag and remove wire 112 (14) and wires G201 (15 and 16) from relay coil terminals. 3. REMOVE RELAY FROM TRANSFORMER PANEL. a. Remove hex head cap screws (17) and flat washers (18). Tag and remove ground wire G201 (15) from relay (19). b. Remove relay (19) from transformer panel. B. INSTALL. 1. INSTALL RELAY ON TRANSFORMER PANEL. Thread locking compound solvent can cause eye damage. Wear safety goggles/glasses when using. Avoid contact with eyes. If solvent contacts eyes, flush with water and get immediate medical attention. a. Clean hex head cap screws (17) with thread locking compound solvent. b. Install flat washer (18) and ground wire G201 (15) onto hex head cap screw (17). GO TO NEXT PAGE 7-20

Privacy Statement
Press Release
Contact