2. CONNECT RELAY WIRES TO RELAY - TM-5-3895-373-20

2. REMOVE RELAY WIRES - TM-5-3895-373-20_670

3. INSTALL BATTERY CABLES - TM-5-3895-373-20_672

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
663

TM 5-3895-373-20 B. INSTALL - Continued. WARNING Thread locking compound can cause eye damage./ Wear safety goggles/glasses when using. Avoid contact with eyes. If compound contacts eyes, flush eyes with water and get immediate medical attention. c. Apply thread locking compound to threads of hex head cap screws (17). d. Install relay (19) with flat washers (18), ground wire G201 (15), and hex head cap screws (17). Tighten cap screws to 9 lb-ft (12 N.m). 2. CONNECT RELAY WIRES TO RELAY. a. Install wires G201 (15 and 16) and wire 112 (14) to relay coil terminals. b. Install flat washers (13) and hex nuts (12) onto both relay coil terminals. Tighten hex nuts to 18 lb-in (0,9 N.m). c. Install wire 166 (11) to relay switch terminal. Install wires 167 (9 and 10) to opposite side relay switch terminal. d. Install flat washers (8) and hex nuts (7) onto both relay switch terminals. Tighten hex nuts to 65 lb-in (7,3 N.m). WARNING Electrical insulating varnish fumes can be harmful if inhaled. Use only in a well ventilated area. Avoid prolonged exposure to fumes. If personnel become dizzy or drowsy during use, get immediate medical attention. e. Apply electrical insulating varnish to relay terminals. GO TO NEXT PAGE 7-21

Privacy Statement
Press Release
Contact