TM 5-3895-373-20
D.
ASSEMBLE Continued.
3.
INSTALL EXTENSION FENDERS.
NOTE
A shim may or may not be installed
between
bearing
mount
and
extension fender. The use of the
shim is determined when installing
the 2 ft auger and fender extension
on the paving machine to ensure the
augers are in a straight line.
a.
Install shim (13), bearing mount (12), and hex
head cap screws (11) onto extension fender (8).
Install shim only if it was found in place during
disassembly.
b.
Install flat washers (10) onto hex head cap
screws (11).
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
c.
Apply thread locking compound (Item 12,
Appendix C) to threads of hex head cap screws
(11).
d.
Install hex nuts (9) and tighten to 90 lb-ft (122
N•m).
e.
Align extension fender (7) with extension fender
(8) and install hex head cap screws (5) and flat
washers (6).
f.
Apply thread locking compound (Item 12,
Appendix C) to threads of hex head cap screws
(5).
g.
Install hex nuts (4) and tighten to 37 lb-ft (50
N•m).
h.
Install hex head cap screws (2), flat washers (3),
and hex nuts (1). Tighten hex nuts.
i.
Remove set screws (14) and install 2 ft
extension shaft (16) into bearing mount (12).
j.
Apply thread locking compound (Item 13,
Appendix C) to threads of set screws (14).
k.
Install set screws (14) into bearing unit (15) and
tighten.
l.
Lubricate bearing unit (15) per LO 5-3895-373-
12.
GO TO NEXT PAGE
15-131
