TM 5-3895-373-20
15.18. REPAIR TWO FOOT AUGER AND FENDER EXTENSION - Continued.
A.
DISASSEMBLE.
1.
REMOVE EXTENSION FENDERS.
a.
Remove hex nuts (1), hex head cap screws (2),
and flat washers (3).
b.
Remove hex nuts (4), hex head cap screws (5),
and flat washers (6). Separate extension fender
(7) from extension fender (8).
c.
Remove hex nuts (9), flat washers (10), and hex
head cap screws (11).
NOTE
A shim may or may not be installed
between
bearing
mount
and
extension fender. The use of the
shim is determined when installing
the 2 ft auger and fender extension
on the paving machine to ensure the
augers are in a straight line.
d.
Remove bearing mount (12) and shim (13) from
extension fender (8). A shim may not be
present.
e.
Loosen set screws (14) on bearing unit (15).
f.
Remove bearing mount (12) from 2 ft extension
shaft (16).
2.
DISASSEMBLE BEARING MOUNT.
a.
Remove hex nuts (17), lockwashers (18), and
hex head cap screws (19). Discard lockwashers.
b.
Remove bearing unit (15) from bearing mount
(12).
c.
Remove lubrication fitting (20), lubrication pipe
(21), and elbow (22) from bearing unit (15).
GO TO NEXT PAGE
15-126
