TM 5-3895-373-20
15.5.
REPLACE HOPPER FLASHINGS AND SCRAPERS - Continued.
C.
INSTALL.
1.
INSTALL RUBBER SHEET FLASHINGS.
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Place flat washers (2) onto hex head cap screws
(1) and apply thread locking compound to
threads of hex head cap screws.
Ensure that center flashing and wing
flashings are not installed backward.
Place reinforcement cords toward the
inside of the hopper.
b.
Install center flashing (5) and retaining plate (4).
Secure with hex head cap screws (1) and hex
nuts (3).
c.
Place flat washers (7) onto hex head cap screws
(6) and apply thread locking compound to
threads of cap screws.
d.
Install left and right wing flashings (10 and I 11)
and retaining plates (8 and 9). Secure with cap
screws (6).
GO TO NEXT PAGE
15-46
