TM 5-3895-373-20C.INSTALL - Continued.NOTEThere is a left hand and a right handscraper on the paving machine. Lefthand scraper installation isaddressed in this procedure.Procedure is identical for right handscraper installation. Left handscraper is shown in this procedure.2.INSTALL SCRAPER.Thread locking compound can causeeye damage. Wear safetygoggles/glasses when using. Avoidcontact with eyes. If compoundcontacts eyes, flush eyes with waterand get immediate medical attention.a.Place flat washers (13) onto hex head capscrews (12) and apply thread locking compoundto threads of cap screws.b.Install scraper (14) using hex head cap screws(12). Hand tighten cap screws.c.Position scraper (14) so there is a gap of 1/16 to1/8 in. (1,5 to 3 mm) between the leading edgeof the scraper and the engine compartmentbulkhead.d.Raise and lower hopper wing per TM 5-3895-373-10 to check clearance of scraper atcompartment bulkhead. Ensure 1/16 to 1/8 in.(1,5 to 3 mm) gap is held at closest pointbetween scraper and compartment bulkhead.e.Tighten hex head cap screws (12) to 59 lb-ft (80N•m).END OF TASK15-47
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business