TM 5-3895-373-20
15.5.
REPLACE HOPPER FLASHINGS AND SCRAPERS - Continued.
A.
REMOVE.
1.
REMOVE RUBBER SHEET FLASHINGS.
a.
Remove hex head cap screws (1), flat washers
(2), and hex nuts (3).
b.
Remove retaining plate (4) and center flashing
(5). Discard center flashing.
c.
Remove hex head cap screws (6) and flat
washers (7).
d.
Remove retaining plates (8 and 9) and left and
right wing flashings (10 and 11). Discard wing
flashings.
NOTE
There is a left hand and a right hand
scraper on the paving machine. Left
hand scraper removal is addressed in
this
procedure.
Procedure
is
identical
for
right
hand
scraper
removal. Left hand scraper is shown
is this procedure.
2.
REMOVE WORN OR DAMAGED SCRAPER.
a.
Remove hex head cap screws (12) and flat
washers (13).
b.
Remove
damaged
or
worn
scraper
(14).
Discard scraper.
GO TO NEXT PAGE
15-44