3. ADJUST MAIN SCREED LEADING EDGE FOR 0.06 TO 0.19 IN. (1,5 TO 4,8 MM) POSITIVE CROWN

2. ADJUST MAIN SCREED TRAILING EDGE FOR ZERO CROWN

15.4. REPLACE/REPAIR CROWN ADJUSTMENT ASSEMBLY - Continued - TM-5-3895-373-20_1072

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
1063

TM 5-3895-373-20 D. ADJUST - Continued. 3. ADJUST MAIN SCREED LEADING EDGE FOR 0.06 TO 0.19 IN. (1,5 TO 4,8 MM) POSITIVE CROWN. a. Position straightedge (26) on bottom leading edge of main screed (27). Visually check crown at center of main screed leading edge. b. Using crown adjustment wrench (13), rotate front sprocket wheel assembly (9) to achieve a 0.06 to 0.19 in. (1,5 to 4,8 mm) positive crown at the center of the main screed leading edge. If crown cannot be obtained, refer to Direct Support for replacement of main screed plate. GO TO NEXT PAGE 15-41

Privacy Statement
Press Release
Contact