TM 5-3895-373-20
B.
CLEAN.
1.
CLEAN METAL PARTS.
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well-ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
III cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Clean all metal parts using cleaning solvent and
a cleaning cloth. Use a wire scratch brush to
remove buildup deposits.
Thread locking compound solvent
can cause eye damage. Wear safety
goggles/glasses when using. Avoid
contact with eyes. If solvent contacts
eyes, flush eyes with water and get
immediate medical attention.
b.
Use thread locking compound solvent to clean
all hex head cap screws. Dry with a clean,
cleaning cloth.
2.
CLEAN MOUNTING SURFACES.
a.
Clean all mounting surfaces exposed by removal
of flashings or scrapers with cleaning solvent
and a cleaning cloth. If necessary, use plastic
hammer to knock away large buildup deposits.
b.
Use cleaning solvent and a wire scratch brush to
remove all remaining buildup deposits from
mounting surfaces.
GO TO NEXT PAGE
15-45