TM 5-3895-373-2015.4.REPLACE/REPAIR CROWN ADJUSTMENT ASSEMBLY - Continued.D.ADJUST - Continued.c.Place roller chain (19) over front and rearsprocket wheel assemblies (9 and 10). To alignthe chain into the sprocket wheel teeth, makesmall, even adjustments to both sprocket wheelassemblies.d.Install connecting link (20) onto roller chain (19).e.Tighten hex nut (14) using crown adjustmentwrench (13).f.Lubricate crown adjustment assembly per LO53895-373-12.g.Recheck front and rear crown. If crown is stillout of adjustment, repeat adjustment procedure.h.Loosen hex nuts (28 and 29). Move crownpointer (30) so pointer indicates "0" on the scale(31). Tighten hex nuts.4.REMOVE EXTENSION SCREED CRIBBING.NOTERefer to TM 5-3895-373-10 for detailedpaving machine operatinginstructions.a.Perform steps b through d by following pavingmachine operating instructions in TM 5-3895-373-10.b.Start up paving machine. Raise screed to fullyraised position.c.Remove all cribbing materials from underextension screeds.d.Fully retract extension screeds. Lower screed.NOTEFOLLOW-ON-TASK:Screed steps raised per TM 5-3895-373-10.END OF TASK15-42
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
