15.4. REPLACE/REPAIR CROWN ADJUSTMENT ASSEMBLY - Continued

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
1060

TM 5-3895-373-20 15.4. REPLACE/REPAIR CROWN ADJUSTMENT ASSEMBLY - Continued. C. INSTALL - Continued. k. Place front sprocket wheel assembly (9) through roller chain (19). Keep the sprocket wheel assembly as close to installation position as possible and place the roller chain onto the sprocket wheel. l. Install front sprocket wheel assembly (9) into mounting brackets on screed. A slight adjustment may be required to ensure alignment with the mounting brackets. Use care when installing retaining rings. Retaining rings are under spring tension and can act as projectiles when released and could cause severe eye injury. m. Install left and right side assembly mounting pins (11). Install retaining rings (15) using snap ring pliers. n. Install solenoid coils (17) and hex nuts (16) onto solenoid valves (18). o. Tighten hex nuts (16) to 13 lb-in (1,5 N•m). GO TO NEXT PAGE 15-38

Privacy Statement
Press Release
Contact