3. INSTALL MOUNTING BRACKET COMPONENTS

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
1050

TM 5-3895-373-20 15.3. REPLACE THICKNESS CONTROL COMPONENTS- Continued. C. INSTALL - Continued. 3. INSTALL MOUNTING BRACKET COMPONENTS. a. Use sleeve from universal puller kit to seat bearing cups (26) into mounting bracket (24). b. Lubricate one tapered cones and rollers (28) with grease. Seat lubricated tapered cobes and rollers in one of the installed bearing cups (26). c. With metal side of seal (27) facing in, center seal in bore of mounting bracket (24). Use plastic hammer to gently tap seal to seat against bearing cup (26). d. Repeat steps b and c at opposite end of mounting bracket (24). e. Install lockwashers (30) onto hex head cap screws (29). Thread locking compound can cause eye damage. Wear safety goggles/glasses when using. Avoid contact with eyes. If compound contacts eyes, flush eyes with water and get immediate medical attention. f. Apply thread locking compound (Item 12, Appendix C) to threads of hex head cap screws (29). g. Install mounting bracket (24) and secure with lockwashers (30) and hex head cap screws (29). Tighten cap screws to 90 lb-ft (122 N-m). GO TO NEXT PAGE 15-28

Privacy Statement
Press Release
Contact