TM 5-3895-373-20
15.3.
REPLACE THICKNESS CONTROL COMPONENTS - Continued.
C.
INSTALL - Continued.
5.
INSTALL INDICATOR, CATCH PLATE, AND
LUBRICATION FITTING.
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Apply thread locking compound
(Item
12,
Appendix C) to threads of hex head cap screw
(5).
b.
Install catch plate (6), hex head cap screw (5),
lockwasher (4), and hex nut (3). Do not
overtighten. Catch plate needs to be movable in
mounting bracket.
c.
Install lubrication fitting (31). Lubricate mounting
bracket with grease until grease is seen at
installed bearings.
d.
Install indicator (2) and position pointer at zero
(0) mark on thickness control decal.
e.
Apply thread locking compound
(Item
13,
Appendix C) to threads of set screw (1).
f.
Install set screw (1). Tighten to 95 lb-in (11
N•m) using hex head driver socket.
NOTE
FOLLOW-ON-TASKS:
Extension screeds fully retracted per TM 5-3895-373-10.
END OF TASK
15-30
