TM 5-3895-373-20
15.3.
REPLACE THICKNESS CONTROL COMPONENTS - Continued.
A.
REMOVE - Continued.
Use care when removing snap and
retaining rings. Snap and retaining
rings are under spring tension and
can act as projectiles when released
and could cause severe eye injury.
b.
Using a flat blade screwdriver and plastic
hammer, drive out retaining rings (43) from all
bearing assemblies. Discard retaining rings.
c.
Place universal joint in bench vise. Lightly tap
universal joint yoke (41) with a plastic hammer to
drive out bearing assembly (44). Remove
bearing assembly.
d.
Remove bearing assembly (44) at opposite side
by turning yoke over and tapping on opposite
side of universal joint yoke. Remove universal
joint yoke (41).
GO TO NEXT PAGE
15-24
