1. CLEAN THICKNESS CONTROL COMPONENTS.

A. REMOVE - Continued - TM-5-3895-373-20_1054

2. CLEAN CAP SCREWS AND MOUNTING HARDWARE

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
1047

TM 5-3895-373-20 A. REMOVE - Continued. e. Hold spider (45) in bench vise and lightly tap universal joint yoke (40) to remove bearing assembly (44). f. Turn universal joint yoke (40) over and tap opposite side to remove remaining bearing assembly (44). g. Discard spider (45) and bearing assemblies (44). B. CLEAN. Cleaning solvent, P-D-680, is TOXIC and flammable. Wear protective goggles and gloves. Use only in a well ventilated area. Avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type III cleaning solvent is 200°F (93,3°C). Failure to do so may result in injury or death to personnel. If personnel become dizzy when using cleaning solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, flush eyes with water and get immediate medical attention. 1. CLEAN THICKNESS CONTROL COMPONENTS. a. Clean all components with cleaning solvent. Use a wire scratch brush to remove hardened deposits. b. Wipe cleaned components dry with a cleaning cloth. GO TO NEXT PAGE 15-25

Privacy Statement
Press Release
Contact