TM 5-3895-373-10
j.
Unscrew and disconnect feed limit switch
connector (1) from the rear wall of the tractor.
k.
Remove endgate assembly using the following
steps.
WARNING
To avoid personal injury, do not
attempt
to
lift
and
remove
the
endgate alone. Endgate weighs
approximately 126 lbs (57,1 kg). Use
a second person to help remove
endgate. Failure to do so may result
in serious injury.
(1)
Release endgate hand levers (2) and
lower endgate (3).
(2)
Unhook chains (4) from endgate hand
levers (2) and with the help of another
person allow endgate (3) to lower enough
for endgate mounting tab (5) to clear bolt-
on screed extension frame (34) during
removal of endgate and endgate support
arm (7).
(3)
Remove
self-locking
nuts
(12),
flat
washers (13), hex head cap screws (14),
and spacer (15).
(4)
With the help of a second person, remove
hex head cap screws (16) and flat
washers (17) securing endgate support
arm (7) to bolt-on screed extension frame
(34).
WARNING
To avoid personal injury, do not
attempt to lift and remove endgate
support arm and endgate alone.
Endgate weighs approximately 126
lbs (57,1 kg ). Use a second person
to help remove endgate support arm
and endgate from screed frame.
Failure to do so may result in serious
injury.
(5)
With the help of a second person, lift
endgate support arm (7) and endgate (3)
from bolt-on screed extension frame (34)
and lay flat on the ground, out of the way.
(6)
Remove hex head cap screws (18),
lockwashers (19), and cover plate (20).
2-91
