TM 5-3895-373-10
i.
Remove I ft and 2 ft auger and fender
assemblies using the following steps.
(1)
Remove
extension
fender
(68)
by
removing hex nuts (67), flat washers (66),
and hex head cap screws (65). Replace
hex head cap screws, flat washers, and
hex nuts in extension fender mounting
holes after removal.
(2)
Remove hex nut (46), lockwasher (47),
hex head cap screw (48), and shaft cover
(49).
(3)
Remove hex nut (60), lockwasher (61),
shaft cover (62), and flat washer (63).
Remove hex head cap screw (64) and
auger extension assembly (59). Replace
hex head cap screw, flat washer, shaft
cover, lockwasher, and hex nut onto auger
extension assembly after removal.
(4)
Remove hex nut (51), lockwasher (52),
shaft cover (53), flat washer (54), and hex
head cap screw (55).
WARNING
To avoid personal injury, do not
attempt to lift and remove the 2 ft
auger and fender extension alone. 2
ft auger and fender extension weighs
approximately
126
lbs
(57,1
kg).
Always use a second person to help
hold the 2 ft extension in place during
removal. Failure to do so may result
in serious injury.
(5)
With the help of a second person, remove
hex nuts (58), flat washers (57), hex head
cap screws (56), and 2 ft auger and fender
extension (50). Replace hex head cap
screws, flat washers, and hex nuts in 2 ft
auger and extension fender mounting
holes after removal.
(6)
Replace hex head cap screw (55), flat
washer (54), shaft cover (53), lockwasher
(52), and hex nut (51) onto 2 ft auger and
fender
extension
auger
shaft
after
removal.
(7)
Install shaft cover (49) onto main auger
shaft and secure with hex head cap screw
(48), lockwasher (47), and hex nut (46).
2-90
