TM 5-3895-373-10
(10)
Match up left and right 1 ft auger
extensions with correct left and right side
of mating auger shaft.
(a)
Visually match the spiral of each I ft
auger extension with that of 2 ft
auger shaft on both left and right
sides.
(b)
Place the 1 ft auger extension so
that
the
mounting
hardware
is
oriented in the same direction as the
mounting hardware on the 2 ft auger
shaft. If the spiral of the auger
flights does not match that of the 2 ft
auger shaft, then the I ft auger
extension being compared belongs
on the opposite side.
(11)
Locate female end of auger extension
assembly (59) and remove hex nut (60),
lockwasher (61), shaft cover (62), flat
washer (63), and hex head cap screw
(64).
NOTE
Auger extensions must be installed
with the same spiral direction as the
2 ft auger shaft. Failure to install
auger extensions properly will cause
poor distribution of paving material
along the length of the screed and
result in poor paving.
(12)
Rotate auger extension so that
mounting hardware for the auger flights is
oriented in the same direction as the
mounting hardware on the mating auger
shaft. Ensure the spiral direction of the
auger flights match the spiral direction of
the 2 ft auger shaft.
(13)
Install female end of auger extension
assembly (59) on the male end of the 2 ft
auger shaft using hex head cap screw
(64), flat washer (63), shaft cover (62),
lockwasher (61), and hex nut (60).
(14)
Install shaft cover (49) using hex head cap
screw (48), lockwasher (47), and hex nut
(46).
(15)
Remove hex head cap screws (65), flat
washers (66), and hex nuts (67) from
mounting hardware location on extension
fender (68).
(16)
Install extension fender (68) using hex
head cap screws (65), flat washers (66),
and hex nuts (67).
(17)
Tighten hex nuts (60 and 67).
2-88