TM 5-3895-373-10
q.
Install 2 ft and I ft auger and fender assemblies
using the following steps.
(1)
First identify left or right 2 ft auger and
fender extension to be installed. The left 2
ft extension has the bearing mount
mounted on the outboard left side of the
extension. The right 2 ft extension has the
bearing mount mounted on the outboard
right side of the extension.
(2)
Remove hex nut (46), lockwasher (47),
and hex head cap screw (48) securing
shaft cover (49). Remove shaft cover.
NOTE
Auger extensions must be installed
with the same spiral direction as the
mating auger shaft. Failure to install
auger extensions properly will cause
poor distribution of paving material
along the length of the screed and
result in poor paving.
(3)
Rotate auger extension on 2 ft auger and
fender extension (50) so that mounting
hardware for the auger flights is oriented in
the same direction as the mounting
hardware on the mating auger shaft.
Ensure the spiral direction of the auger
flights match the spiral direction of the
mating auger shaft.
(4)
Remove hex nut (51), lockwasher (52),
shaft cover (53), flat washer (54) and hex
head cap screw (55) from the end of the
auger extension shaft.
(5)
Remove hex head cap screw (56), flat
washers (57), and hex nuts (58) from
mounting locations on 2 ft auger and
fender extension (50).
WARNING
To avoid personal injury, do not
attempt to lift and install 2 ft auger
and fender extension alone. 2 ft
auger and fender extension weighs
approximately
120
Ibs
(54,4
kg).
Always use a second person to help
hold 2 ft extension in place during
installation. Failure to do so may
result in serious injury.
(6)
With the help of a second person, install 2
ft auger and fender extension (50) female
end on male end of mating auger shaft.
Align auger and extension fender with
mounting surface on paving machine main
frame.
(7)
Install hex head cap screws (56), flat
washers (57), and hex nuts (58) to attach
the auger and extension fender to the
main frame of the paving machine.
(8)
Install hex head cap screw (55), flat
washer (54), shaft cover (53), lockwasher
(52), and hex nut (51).
(9)
Tighten hex nuts (51 and 58).
2-87
