TM 5-3895-373-34
A.
REMOVE - Continued.
NOTE
Perform steps 5 and 6 if removing right
auger/ conveyor motor. Go to step 7 if
removing left auger/conveyor motor.
Hydraulic oil can be moderately flammable
and can be an irritant to the skin, eyes, and
respiratory
system.
Avoid
prolonged
exposure. Eye protection and rubber
gloves must be worn when working with
hydraulic oil.
5.
DISCONNECT SCREED EXTENSION CYLINDER
EXTEND AND RETRACT HYDRAULIC HOSES
AND SCREED VIBRATION CONTROL VALVE
TUBES AT TRACTOR REAR BULKHEAD.
Cleaning solvent, P-D-680, is TOXIC and
flammable. Wear protective goggles and
gloves. Use only in a well ventilated area.
Avoid contact with skin, eyes, and clothes,
and do not breathe vapors. Keep away
from heat or flame. Never smoke when
using solvent; the flashpoint for Type III
cleaning solvent is 200°F (93,3°C). Failure
to do so may result in injury or death to
personnel.
If personnel become dizzy while using
cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin
or clothes, flush with cold water. If solvent
contacts eyes, flush eyes with water and
get immediate medical attention.
a.
Clean area around hydraulic hose and tube
fittings with a cleaning cloth moistened with
cleaning solvent.
Be careful not to bend metal tubes during
removal or moving out of the way during
maintenance. Tubes may develop cracks or
burst if damaged by bends or cracks.
b.
Tag and disconnect screed vibration control
valve tubes (28 and 29) from straight adapters.
GO TO NEXT PAGE
2-973
