TM 5-3895-373-34
D.
INSTALL - Continued.
5.
CONNECT
CROWN
ADJUSTMENT
ASSEMBLY.
a.
Lift loosened side of crown adjustment assembly
(74) and install onto main screed frame.
b.
Install mounting pins (73) into main screed
frame.
WARNING
Use care when installing retaining
rings. Retaining rings are under
spring
tension
and
can
act
as
projectiles when released and could
cause severe eye injury.
c.
Install retaining rings (72) using snap ring pliers.
d.
Install pointer (75) through left hand main screed
frame, with threaded end positioned between left
hand and right hand main screed frames.
e.
Install hex nut (76) and lockwasher (77) onto
pointer (75), as far as is required to align
matchmark
made
during
removal.
Slide
threaded end of pointer through right hand main
screed frame.
f.
With matchmarks aligned, install lockwasher
(77) and hex nut (76) onto threaded end of
pointer (75). Do not tighten hex nuts at this time.
g.
Install
thumbscrews
(78)
through
crown
adjustment wrench (79) and attach crown
adjustment wrench onto right hand main screed
frame.
h.
Install C-clamp and spacer wedges between left
hand and right hand main screed frames per
paragraph 2.71, step B.3. Set spacer wedges to
measurement recorded in A.9.g.
GO TO NEXT PAGE
2-947
