TM 5-3895-373-34 2.49 REPAIR AUGER/CONVEYOR, VALVE AND CYLINDER, AND TOW POINT FLOW DIVIDERS - Continued. D. ASSEMBLE. 1.    INSTALL  SHAFTS,  DOWEL  KEYS,  GEARS,  AND RETAINING RINGS ONTO SPACER PLATE. WARNING Hydraulic oil can be moderately flammable  and  can  be  an  irritant  to the skin, eyes, and respiratory system.    Avoid  prolonged  exposure. Eye    protection    and    rubber    gloves must   be   worn   when    working    with hydraulic oil. a. Dip all metal spacer plate parts being assembled in clean hydraulic oil prior to assembly. b. Install    shafts    (28)    through    bearings    (26)    in spacer plate (22). WARNING Use    care    when    installing    retaining rings.        Retaining    rings    are    under spring tension and can act as projectiles  when  released  and  could cause  severe eye injury. c. Use  snap  ring  pliers  and  install  inner  retaining rings (27) onto shaft (28). NOTE Illustration shown is for auger/conveyor and valve and cylinder  flow  dividers.     If   tow   point flow  divider  gear  and  shaft  assembly is  being  assembled,  metal  balls  will be installed on shaft instead of dowel keys.  Procedure is the units. NOTE Gears  shown  are  for  auger/conveyor and  valve  and  cylinder  flow  dividers. Gears  for  tow  point  flow  divider  are narrower than those in auger/ conveyor and valve and cylinder flow dividers.  Procedure for installation is the same for all same for all units. e. Install gears (29) on each shaft (28). d. Install  dowel  keys  (30)  or  metal   balls   (31)   on each  shaft  (28).    f.    Use  snap  ring  pliers  and install outer retaining rings (27). GO TO NEXT PAGE 2-670