TM 5-3895-373-34
2.36
REPLACE/REPAIR TRACK IDLER ROLLER ASSEMBLY - Continued.
A.
DISASSEMBLE Continued.
2.
DISASSEMBLE
TRACK
IDLER
ROLLER
ASSEMBLY.
a.
Remove set screws (6).
NOTE
The circular end of the track slide is
offset so that the longer flat surface is on
the bottom.
b.
Position track idler roller assembly on its side
with RH track slide (7) up. Place cribbing (8)
below track idler roller (9) to prevent tipping.
c.
Secure track idler roller assembly to workbench
with a C-clamp.
d.
Remove
hex
head
cap
screws
(10)
and
lockwashers (11). Lift RH track slide (7) from
shaft (12). Discard lockwashers.
e.
Lift shaft (12) from track idler roller (9). Remove
and discard plain seal (13) from RH track slide
(7).
f.
Remove
hex
head
cap
screws
(14)
and
lockwashers (15). Remove idler shaft bracket
(16). Discard lockwashers.
LH
and
RH
track
slides
are
not
interchangeable
with
each
other.
Ensure that the LH and RH track slides
are separated out so as not to be
intermixed.
g.
Remove track idler roller (9) and plain seal (17)
from LH track slide (18). Discard plain seal.
GO TO NEXT PAGE
2-508
