TM 5-3895-373-34
2.33
REPLACE/REPAIR SPEED REDUCTION GEARBOX - Continued.
F.
INSTALL Continued.
2.
INSTALL FLANGE COMPONENTS.
NOTE
Ring seal (16) can only be installed on
brake mounting side of flange (14).
a.
Lubricate ring seal (16) with petrolatum. With
sealing lip up, use plastic hammer to evenly tap
ring seal into flange (14).
b.
Install gasket (15) on mating flange of brake
(10).
c.
Line up edge lobe of flange (14) with installed
straight adapter (2).
d.
Carefully slide flange (14) with installed ring seal
(16) over shouldered shaft of brake (10).
Thread locking compound can cause
eye damage. ear safety goggles/glasses
when using. Avoid contact with eyes. If
compound contacts eyes, flush eyes
with water and get immediate medical
attention.
e.
Apply thread locking compound
(Item
13,
Appendix B) to threads of bolts (13). Install
bolts. Using hex head driver socket (Item 88,
Appendix D), evenly tighten bolts to 45 Ib-ft (61
N•m).
Use care when installing retaining rings.
Retaining rings are under spring tension
and can act as projectiles when released
and could cause severe eye injury.
f. Use snap ring pliers to install retaining ring (12)
in mating groove of spline coupling (11).
g. With retaining ring end of spline coupling (11)
facing down, insert coupling into mating
shouldered shaft of brake (10).
GO TO NEXT PAGE
2-492
