TM 5-3895-373-34
E.
ASSEMBLE Continued.
Be careful not to damage preformed packing when
sliding over threads. Sharp edges of threads can cut or
damage preformed packing. Damaged preformed
packing will cause leakage and affect performance.
y.
Apply petrolatum to preformed packing (40).
Install preformed packing in mating groove of
straight adapter (2).
Be careful not to overtighten threaded
brass components (2, 3, 38, and 39)
during installation. Overtightening will
cause stripping of screw threads or
shearing off of brass component.
z.
Screw straight adapter (2) into mating port of
brake housing (23) until installed preformed
packing (40) meets packing seat. Carefully
tighten adapter and install protective cap on
exposed threads of straight adapter.
aa.
Install and carefully tighten plug (3), liquid sight
indicator (38), and breather (39) with seal rings
(4) in mating ports of brake housing (23).
F.
INSTALL.
1.
INSTALL BRAKE ON SPEED REDUCTION
GEARBOX.
a.
Lubricate o-ring (24) with petrolatum. Install o-
ring on mating flange of installed internal gear
(47).
b.
Align matchmarks on brake (10) and speed
reduction gearbox (8). Seat brake on gearbox.
Thread locking compound can cause
eye damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound contacts
eyes, flush eyes with water and get
immediate medical attention.
c.
Apply thread locking compound
(Item
14,
Appendix B) to threads of bolts (22). Install and
securely tighten bolts.
GO TO NEXT PAGE
2-491
