TM 5-3895-373-34
G.
INSTALL.
1.
INSTALL
HYDRAULIC
FlTTINGS
ONTO
PROPULSION MOTOR.
Hydraulic oil can be moderately flammable
and can be an irritant to the skin, eyes, and
respiratory system. Avoid prolonged expos-
ure. Eye protection and rubber gloves must
be worn when working with hydraulic oil.
a.
Lubricate preformed packings (19 and 20)
with clean hydraulic oil.
Be careful not to damage preformed packing
when sliding over threads. Sharp edges of
thread
can
cut
or
damage
preformed
packing. Damaged preformed packing will
cause leakage and affect performance.
b.
Install preformed packings (19 and 20) onto
straight adapters (17 and 18). Install
straight adapters onto propulsion motor
(10).
c.
Lubricate preformed packings (16) with
clean hydraulic oil. Install preformed
packings onto propulsion motor (10).
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
d.
Apply thread locking compound (Item 13,
Appendix B) to threads of socket head cap
screw (15).
e.
Install adapter blocks (14) and socket head
cap screws (15). Use a hex head driver
socket (Item 91, Appendix D) and tighten
cap
screws
to
45
lb-ft
(61
N•m).
f.
Install preformed packings (13) onto elbows
(12). Screw elbows into adapter blocks
(14) until packing meets packing seat in
mating adapter block port. Aim elbow to
point toward left side of propulsion motor
(10). Tighten adapter nut.
GO TO NEXT PAGE
2-467
