TM 5-3895-373-34
2.32
REPLACE/REPAIR PROPULSION MOTOR - Continued.
E.
ASSEMBLE - Continued.
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
h.
Coat outer surface of tube (61) with thread
locking compound (Item 14, Appendix B).
NOTE
Tube (61) is pressed-fit into port plate
housing (46).
i.
Install tube (61) into port plate housing (46).
Hydraulic
oil
can
be
moderately
flammable and can be an irritant to
the
skin,
eyes,
and
respiratory
system. Avoid prolonged exposure.
Eye protection and rubber gloves
must be worn when working with
hydraulic oil.
j.
Lubricate preformed packing (59) and o-
ring (60) with clean hydraulic oil.
k.
Install preformed packing (59) and o-ring
(60) into port plate cover (57).
l.
Apply thread locking compound (Item 13,
Appendix D) to threads and install socket
head cap screws (58 through port plate
cover (57) and into port plate housing (46).
Use a hex head driver socket (Item 90,
Appendix D) and tighten cap screws to 10
lb-ft (14 N•m).
m.
Coat threads of nozzle (56) with thread
locking compound (Item 14, Appendix B).
n.
Install nozzle (56) into port plate cover (57).
GO TO NEXT PAGE "
2-460
