TM 5-3895-373-34
2.32
REPLACE/REPAIR PROPULSION MOTOR - Continued.
E.
ASSEMBLE - Continued.
2.
MEASURE
DEPTH
OF
PORT
PLATE
IN
RELATION
TO
PORT
PLATE
HOUSING
FLANGE.
a.
On a level, clean surface, insert port plate
(47) into port plate housing (46).
b.
Level port plate (47) in port plate housing
(46).
c.
Use a micrometer depth gage and measure
depth (A) of port plate in relation to port
plate cover flange.
d.
Write measurement down and retain for
reassembly of cylinder block.
3.
INSTALL CYLINDER BLOCK INTO MECHAN-
ICAL
DRIVE
HOUSING
AND
MEASURE
CYLINDER BLOCK END PROJECTION.
a.
Install shaft (67) into cylinder block (63).
Use care when installing snap and retaining
rings. Snap and retaining rings are under
spring tension and can act as projectiles
when released and could cause severe eye
injury.
NOTE
Retaining ring will fit between ball end of
shaft and flange of shaft when installed in
cylinder block.
b.
Use snap ring pliers to install retaining ring
(64) between ball end of shaft and flange of
shaft. Ensure retaining ring is fully seated
in cylinder block (63).
Hydraulic oil can be moderately flammable and can
be an irritant to the skin, eyes, and respiratory
system. Avoid prolonged exposure. Eye protection
and rubber gloves should be worn with clean
hydraulic oil.
c.
Lubricate piston holes inside of cylinder block
(63)
when working with hydraulic oil.
GO TO NEXT PAGE
2-456
