TM 5-3895-373-34
2.32
REPLACE/REPAIR PROPULSION MOTOR - Continued.
E.
ASSEMBLE - Continued.
Use care when removing snap and
retaining rings. Snap and retaining
rings are under spring tension and
can act as projectiles when released
and could cause severe eye injury.
m.
Remove retaining ring (64) and ring spacer
(66) from cylinder block (63).
NOTE
Shims (65) may be needed to obtain
correct cylinder block projection.
n.
Add shims (65) as needed to obtain correct
cylinder block projection. Repeat steps g
through I as needed.
4.
INSTALL
SPRING,
RING
SPACER,
AND
RETAINING RING INTO CYLINDER BLOCK.
a.
Install spring (62) and ring spacer (66) back
into cylinder block (63).
b.
Install a bearing puller, using hex head cap
screws
(Item
27,
Appendix
D)
into
mechanical drive housing.
Use care when installing snap and
retaining rings. Snap and retaining
rings are under spring tension and
can act as projectiles when released
and could cause severe eye injury.
c.
Compress spring (62) and install retaining
ring (64) into cylinder block (63) retaining
ring groove.
NOTE
Ensure retaining ring is fully seated
in
cylinder
block
retaining
ring
groove.
d.
Release spring (62).
e.
Remove bearing puller and hex head cap
screws.
GO TO NEXT PAGE
2-458
