TM 5-3895-373-34
B.
DISASSEMBLE - Continued.
h.
Remove set screws (74 and 75) and plug
(76).
i.
Use a plastic hammer and tap shaft
assembly (77) lightly into mechanical drive
housing.
Use care when removing snap and retaining
rings. Snap and retaining rings are under
spring tension and can act as projectiles
when released and could cause severe eye
injury.
j.
Use retaining ring pliers and remove
retaining ring (78).
k.
Install bearing puller onto mechanical drive
housing.
l.
Attach bearing puller to shaft assembly.
m.
Pull shaft assembly (77) from mechanical
drive housing.
n.
Remove bearing puller and screws from
mechanical drive housing.
C.
CLEAN.
1.
CLEAN ALL METAL PARTS IN CLEANING
SOLVENT.
Cleaning solvent, P-D-680, is TOXIC and
flammable. Wear protective goggles and
gloves. Use only in a well ventilated area.
Avoid contact with skin, eyes, and clothes,
and do not breathe vapors. Keep away from
heat or flame. Never smoke when using
solvent; the flashpoint for Type III cleaning
solvent is 200°F (93,3°C). Failure to do so
may result in injury or death to personnel.
If personnel become dizzy while using
cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or
clothes, flush with cold water. If solvent
contacts eyes, flush eyes with water and get
immediate medical attention.
a.
Rinse all metal parts in cleaning solvent.
GO TO NEXT PAGE
2-451
