TM 5-3895-373-34
2.32
REPLACE/REPAIR PROPULSION MOTOR - Continued.
C.
CLEAN - Continued.
Use caution when scraping residue from
flanges of mechanical drive housing and port
plate housing. Putty knife may score sealing
surfaces and debris may fall into open ports.
Failure to do so may result in poor sealing
and equipment damage.
b.
Use a putty knife to scrape sealant residue
from flanges of mechanical drive housing
and port plate housing.
Compressed air used for cleaning purposes
will not exceed 30 psi (207 kPa). Use only
with effective chip guarding and personal
protective equipment (goggles/face shield,
and
gloves).
Failure
to
take
proper
precautions may result in severe injury or
loss of vision.
c.
Use
30
psi
(207
kPa)
maximum
compressed air to remove any foreign
matter from housings, threaded surfaces,
bores, and valve seats.
d.
Dry all parts with a clean, lint-free cloth.
Thread locking compound solvent can cause
eye damage. Wear safety goggles/glasses
when using. Avoid contact with eyes. If
solvent contacts eyes, flush eyes with water
and get immediate medical attention.
2.
CLEAN FASTENERS, SET SCREWS AND
PARTS
TREATED
WITH
THREAD
COMPOUND
IN
THREAD
LOCKING
COMPOUND SOLVENT.
a.
Clean hex head cap screws, socket head
cap screws and set screws with thread
locking compound solvent.
b.
Clean valve sleeve, pin, nozzle, and tube
with thread locking compound solvent.
c.
Wipe fasteners, set screws, and parts with
a clean, lint- free cloth.
GO TO NEXT PAGE
2-452
