TM 5-3895-373-34
2.30
REPLACE/REPAIR PROPULSION PUMP - Continued.
G.
ADJUST - Continued.
h.
Remove cap (110) and loosen hex nut (111)
while holding special screw (113) with an alien
wrench.
i.
Set throttle control idle to MAX. Refer to TM
53895-373-10.
j.
Turn special screw (113) in either direction until
both pressure gauge readings are equal.
k.
Turn special screw (113) clockwise until one of
the pressure gauge readings increases. Turn
special
screw
counterclockwise
until
other
pressure gauge reading increases. Note the
number of turns in the counterclockwise rotation
until
the
second
pressure
gauge
reading
increases.
l.
Turn special screw (113) clockwise, half the
amount of rotation noted in step k.
m.
While holding special screw (113) from turning,
use an adapter and a crowfoot wrench (Item
120, Appendix D) to tighten hex nut (111) to 15
Ib-ft (20 N.m).
n.
Shut off engine and remove key from ignition
switch. Refer to TM 5-3895-373-10.
o.
Install cap (110).
GO TO NEXT PAGE
2-434
