TM 5-3895-373-34
F.
INSTALL - Continued.
g.
Install upper hex head cap screw (19) with
lockwasher (20) and flat washer (21) assembled
through propulsion pump (22) and gasket (24).
h.
Lift and install propulsion pump (22) into pump
drive gearbox (23). A slight rotation of pump
may be required in order to align pump shaft
splines with pump drive gearbox.
i.
Install but do not tighten hex head cap screw
(19).
j.
Install lower hex head cap screw (19) with
lockwasher (20) and flat washer (21) assembled
through propulsion pump, gasket (24), and into
pump drive gearbox. Tighten cap screws (19).
2.
CONNECT
HYDRAULIC
HOSES
AND
ELECTRICAL
CONNECTIONS
TO
IGHT
PROPULSION PUMP.
Hydraulic fitting sealant can cause eye damage
or skin irritation. Wash after skin contact. Wear
safety goggles/glasses when using. Avoid
contact with eyes or skin. If sealant contacts
eyes, flush eyes with water and get immediate
medical attention.
a.
Apply hydraulic fitting sealant to straight adapter
(39) and elbows (35, 37, 41, and 44).
b.
Connect case drain hose (10) to propulsion
pump. Tighten drain hose.
c.
Connect propulsion motor hoses (9 and 8) to
propulsion pump. Tighten motor hoses, using
combination wrench (Item 115, Appendix D).
d.
Connect hydraulic charge filter hoses (7 and 6)
to propulsion pump. Tighten charge filter hoses.
e.
Connect propulsion pump suction hose (5) to
propulsion pump. Tighten suction hose, using
combination wrench (Item 116, Appendix D).
GO TO NEXT PAGE
2-429
