TM 5-3895-373-34
2.30
REPLACE/REPAIR PROPULSION PUMP - Continued.
B.
DISASSEMBLE Continued.
10.
REMOVE FRONT COVER, GASKET, AND
SWASH PLATE.
a.
Turn end cap assembly housing so front cover
(83) is facing up.
Do not remove front cover until A-flange
adapter has been removed. Damage to
propulsion pump may occur if woodruff
key (Item 72, step 7) is not removed
before front cover.
NOTE
Spring tension may force front cover up
0.125 in.(3,18 mm) when screws are
removed.
b.
Remove screws (84 and 85) from front cover
(83).
c.
Pull front cover (83) and gasket (86) from end
cap assembly housing. Discard gasket.
NOTE
Sleeve bearings may stay attached to
swash plate during front cover removal.
d.
Remove swash plate (87).
e.
Remove sleeve bearing (88) from swash plate.
NOTE
Pin (89) may be removed with front cover
or stay in end cap assembly housing.
GO TO NEXT PAGE
2-404
